Blog

How to Change a Drill Bit 

How to Change a Drill Bit

There are several ways to change a drill bit. However, knowing the correct procedure is essential to your success. Read the BDL Shopping Center guide on how to change a drill bit. Here are some simple steps to follow:  

1. Remove the Old Drill Bit 

Place the new one into the chuck. Rotate the chuck so that the chuck and bit are in the same position. 

2. Tighten the Chuck 

Depending on the type of drill, you may need to turn the chuck key counterclockwise. If not, the bit may fall out. Do not use too much force to remove it. Make sure the chuck is not loose and that the bit cannot move freely. 

3. Insert a Key  

Some drills come with a keyed chuck, which you will need to change the drill bit in. You can usually find this key in your drill box. To change the bit, push the direction selector near the trigger to the right. This will loosen the chuck. When you are finished, make sure to hold the drill with both hands, pointing it upwards. 

4. Use Protective Gear 

You should wear gloves when working with drill bits. Ensure that you are wearing eye protection and protective eyewear. You should also be sure to remove any damaged areas on the drill bit. If it’s cracked or bent, replace it right away. If the drill bit has a dull point, it is probably due to overheating. 

BDL Shopping Center | BDL Equipment | BDL Shop | BDL | Shopping Malls Canada
cordless screwdriver with a set of drill bits and self-tapping screws on black background BDL equipment store

While this step isn’t particularly difficult, it’s essential to know how to insert the new bit. The chuck is the part that holds the drill bit in place. It has three jaws, which open and closes depending on the direction of the chuck. To install a new bit, you must make sure that the new one is centered within the chuck. If the new bit is not centered properly, it will get stuck between the jaws and make it impossible to work. 

Power drills are extremely versatile tools, but they must be fitted with the correct drill bit to use them effectively. It is a relatively simple process to replace a drill bit, whether it is keyless or keyed chuck. In most cases, changing the drill bit takes just a few minutes and requires light handling. 

The drill chuck is another important part of the process. While a keyless chuck is less complicated, a keyed chuck requires a specialized key to rotate. It is important to ensure that the chuck is not stripped because if it is, it will cause problems later on. This may prevent you from adjusting the drill. Changing a drill bit isn’t hard, but it’s more difficult to change a small bit. 

There are several types of drill chucks and the process is slightly different. The chuck holds the bit and is typically equipped with three or four claws. When you need to change a drill bit, you must carefully loosen the jaws and pull the chuck forward. You can then insert the new bit. Follow BDL Shopping Center on Facebook, TikTok, and Instagram. Here is the website: BDL Shop 

Back to list

Related Posts

Leave a Reply

Your email address will not be published. Required fields are marked *